Extra Information; Troubleshooting; Troubleshooting Table - Inventum VVW6035AW Benutzerhandbuch

8

Extra information

WATER HARDNESS LEVEL SETTINGS (SALT CONSUMPTION)
Level German hardness
[dH]
1 0-5
2 6-11
3 12-17
4 18-22
5 23-31
6 32-50
RINSE AID CONSUMPTION SETTINGS
Level Number of rinse aid doses that is dispensed
1 Rinse aid not dispensed
2 1 dose
3 2 doses
4 3 doses
5 4 doses
9

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.

TROUBLESHOOTING TABLE

Problem
The program does not start.
The detergent reservoir contains
detergent residues.
French hardness
[dF]
0-9
10-20
21-30
31-40
41-55
56-90
Possible cause
The mains plug is not connected.
There is a problem with the fuse.
There is no water supply.
The door of the appliance is open.
The appliance is switched off.
The water inlet hose and filters are
clogged.
The detergent reservoir is filled while
the reservoir was still damp.
British hardness [dE] Display indicator
0-6 L1
7-14 L2
15-21 L3
22-28 L4
29-39 L5
40-63 L6
Display indicator
r1
r2
r3
r4
r5
'Resetting the program'
Possible solution
Connect the mains plug.
Do a check on the fuse box.
Open the water tap.
Close the door.
Start the appliance. Refer to section
'Starting the appliance'
Make sure that the water inlet hose
and the filters are not clogged.
Make sure that you fill the detergent
reservoir when it is dry.
English
.
.
• 53