Linder ARKIP 460 Bedienungsanleitung Seite 24

Motor
Only CE-marked motors meeting the
requirements of ISO11547 may be
fitted. Engine mounting washers have
been supplied with the boat, and these
need to be utilised when fitting the
engine.
For correct handling of the motor,
read the motor instruction book. There
must be a device that prevents starting
the motor when a gear is engaged.
Engine kill cord/lanyard must be
used (D).
Manoeuvrability
Do not equip or use an engine with
higher power than is stated on the
blue plate in the boat (W). Do not
drive the boat at high speed in heavily
trafficed waters or in weather condi-
tions involving reduced sight or high
seas. Breaking waves makes a high
security risk. Respect and obey speed
restrictions and other traffic regula-
tions. Follow international searoute
rules (COLREGS) and national traffic
instructions.
24 (68)
Automatic bilge pump
The boat is equipped with an auto-
matic bilge pump. Check periodically
the function on the bilge pump (C).
If the power supply dies, you can use
the manual bilge pump (see picture
on page 23). If the bilge pump valve
needs to be cleaned, can you go throw
the inspection hatch. The upper section
of the bilge pump is lifted out by pres-
sing the snap lock fittings together.
Reassemble the valve in reverse order.
From the year model -08 the positions
AUT and MAN are in the panel.
– Position AUT
In normal position the MAN
bilge pump is in AUT posi-
tion and the bilge pump
bail the boat automatically
if needed. Always make
sure that there is sufficient
power in the battery (C).
AUT
– Position MAN
In position MAN the pump is operated
manually.
Note that the main power switch has
no effect on the bilge pump.
If the bilge pump does not work
Please check the following;
– The battery is fully charged and
connected
– The fuse has not blown
– The filter to the pump is clean and
free from debris
– The wiring to the pump and switch
is intact
If the pump fails and the boat fills
with water, it may overrun the battery,
which will short out the electrical sys-
tem and may cause galvanic corrosion
to the boat.
The bilge pump is not meant to be
able to bilge the boat after a hull dama-
ge. The pumps capacity is max 38 l/min.
Loading (W)
Do not exceed the maximum loading
capacity for this boat. Refer to the
specification table in this manual or the
manufacturer's plate on the boat for
the maximum load capacity of the boat.
Distribute the load evenly in the boat to
help counterbalance the weight of the
outboard. Avoid a high placement of
heavy items. Secure the load well. Never
exceed the approved number of people
in the boat. For your own comfort and
safety, lower the speed in bad weather.