Charging Status - Klarstein 10009786 Bedienungsanleitung

3. Directional buttons(Forward, Backward, Leftward, Rightward ):
Press the arrow buttons to control the robot to walk in the designated direction.
Forward - Press this button to make the robot clean forward and it will automatically stop when meet
obstacle.
Rightward - Press this button once to make the robot turn right by about 10°, then clean forward
and automatically stop when meet an obstacle, if you need a longer angle, please press and hold
this button till satisfactory angle is achieved.
Leftward - Press this button once to make the robot turn left by about 10°,then sweep forfard and
automatically stop when meet an obstacle,if you need a longer angle, please press and hold this
button till satisfactory angle is achieved.
Backward - Press this button once to make the robot walk beackward for about 0,3m, if you need a
longer distance, press the hold button till the robot reaches a satisfactory location.

Charging Status

01. When the cleaner is being charged manually, it will not work when you press any button unless
your pull out the plug of power adapter.
02. A full charging time is 3-5 hours, for the first 3 times of charging of a new cleaner, please ensure
it to be charged for more than 12 hours each time, please try to use out the battery power before
charging (ensure a 12-hour charging before you use the robot for the first time).
03. If you press the AUTO button on the remote controller while the cleaner is being charged on the
charging dock station, the robot will draw back from the dock station and turn around to walk
1m ahead, and then it will enter the AUTO mode for working.
04. The robot will enter the standby status when the power supply is cut off during the charging
process.
05. While the robot is being recharged on the station, if the preset time is reached, the robot will
draw back from the station and turn around to walk 1m ahead, and then it will enter the AUTO
mode for working.
06. By pressing the "Full-Go" button on the charging dock station, when the cleaner has been fully
charged on the dock station, it will draw back from the dock station and turn around to walk 1m
ahead, and then it will enter the AUTO mode for working.
07. While the robot is searching the station for recharge, if the battery power is lower than 8% of the
capacity, the robot will stop searching and enter the parking mode in a clear and bright place, and
it will sounds a "Toot" every 30 seconds.
08. During the charging process, the digital display will show the time of charging, 10 times of the
displayed value equals to the actual time of charging (min.)
The working time of the robot will also be shown during the cleaning process,
If more than one above buttons were pressed at
the same time, the
status will be uncertain.
The effective distance of the remote controller is
5-7 meters, which
varies according to different surrounding.
but the value displayed is the actual time of working (min.).
18