Charging The Vacuum Cleaner - Klarstein TurboHybrid Bedienungsanleitung

CHARGING THE VACUUM CLEANER

Note: Before using your vacuum cleaner for first time, charging the vacuum
cleaner for approximately 5hours. A fully charged battery will give approximately
30~50mins of continuous vacuum cleaning.
1. Put the base on a flat, horizontal, stable surface that is not exposed to direct sunlight
or humidity, and far from any heat source.
2. Make sure the appliance is set to off, put the charger into base, then, plug it into a
wall socket.
3. The LED light on the handy vac will start blinking to show that the battery is
charging, when the battery is fully charged, the LED indicator light should glow
solid white (No longer blink)
Notes and tips
• The Charger might warm up during charging, this is normal, it will cool down as
soon as the charging process is over
• When you notice the motor is turning less quickly, it means that the battery needs to
be charged completely.
• It can be useful from time to time (Once a month) to completely discharge the
battery, and then completely recharge it, to maintain optimal performance.
• Recharge after every use
• When start to charge the battery, The LED Light start flash, after the electricity is full,
the three lights will keep bright for 50 seconds, afterwards, the LED lights will turn
off automatically.
EN
17