Klarstein 10009786 Bedienungsanleitung Seite 23

Step for assamble main brush
01. Put the clutch upper cover on the shaft of main brush .(see in Image1)
02. Insert the square side of main brush to the metal square port ,then pack the main brush and
clutch into the other side.(see in Image2)
03. Lock the clutch with screwdriver and screw.(see in Image3)
How to clean center Brush
For a better cleaning effect, please regularly clean out the hair, yarn and large debris en-winded or
adhered on the main brush and the dust on the suction inlet.
01. Directly use the cleaning brush to clean paper scraps or minute particles.
02. En-winded hair, yarn or similar objects should be cut by scissors or pulled out by hand while
carefully rotating the main brush.
Cleaning Sensors
01. The sensors should be cleaned by cotton swab or soft cloth.
02. The wall-following sensors are installed in the front of bumper of the cleaner, the ground detection
sensors are installed at the front bottom of the cleaner (see the figure below)
Storing the Robot
The robot should be stored in ventilated and dry places.
Image 2
Image 1
To ensure a more effective cleaning of this robot, please
clean the sensors regularly.
Image 3
23