Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
04. Take out the filter sponge inside the outlet window (See figure 5).
05. The scouring pad and the filter sponge can be cleaned in water and then reinstalled after drying.
It's recommend to generally clean them.
Installation:
01. Suction inlet: Install the filter sponge and the scouring pad onto the filter mesh bracket orderly,
and then install them into the dustbin.
02. Suction outlet: First install the filter sponge in the outlet window, and then insert the top end of
the outlet window into the dustbin, and then press the fastener at the lower end to fix it.
Figure 1
Side Brush
Step for assemble and disassemble side brush:
01. Take out screwdriver ,side brush and screw which was set in package
02. Put the upper cover downward (see in image2),put the side brush into the shaft with force, then
lock side brush with screwdriver.(see in image3)
03. If need replace side brush ,unscrew the screw which fixed side brush with screwdriver. Repeat
the above step to change new brush.
Remarks: Please follow the step 01,02 before your first using ,or it maybe has an influence on the
function.
Main Brush
Step for disassamble main brush
01. Put the upper cover downward ,take out the screw which was located in the left of main brush with
screwdriver.(see in image1)
02. Take out the main brush.(see in image2)
03. Separate the clutch upper cover and main brush.(see in image3)
Figure 2
Figure 4
Image 1
Image 2
Image 1
Figure 3
Figure 5
Image 2
Image 3
Image 3
22
Werbung
Inhaltsverzeichnis
