Rega PLANAR 3 50TH ANNIVERSARY EDITION Bedienungsanleitung Seite 11

Warnings
Do not unplug the power supply from the turntable whilst the unit is on - turn off the power supply before unplugging. Do not operate the power
supply without the turntable connected. A 24V AC plus a 20V DC signal is present on the pins of the plug - if these are shorted it will cause damage
to the power unit. Use only with the Rega PS1 power supply or Neo PSU MK2. Never expose the unit to rain or moisture. Do not open the case covers.
There are no user serviceable parts inside.
The Neo PSU MK2 incorporates resettable fuses in the driver amplifier to protect it from overcurrent faults, which will cause the turntable to
run erratically or not at all. If in the rare circumstance these are activated, they are reset by turning off the Neo PSU MK2 via the front panel for
approximately 10 seconds. If the fault should persist, consult your dealer.
Specifications - Neo PSU MK2
Output to Motor Bi-phase
Power Consumption
Voltage
Speed Control Step Size
Power Supply
Stroboscopic Disc
The Basic One Bar per Minute Drift Resolution
Specifications - Mains
PS1 (UK)
Input
Output
PS1 (EU)
Input
Output
PS1 (AUS/NZ)
Input
Output
PS1 (KR)
Input
Output
PS1 (USA)
Input
Output
PS1 (JPN)
Input
Output
24V AC protected by resettable fuse.
7.2W
24V AC
0.01 rpm
Rega PS1 only.
100Hz, 180 marks 331/3 rpm
0.016%
230V AC 50Hz 0.07 A
24V AC 350mA AC
230V AC 50Hz 0.07 A
24V AC 350mA AC
230V AC 50Hz 0.07 A
24V AC 350mA AC
220V AC 50/60Hz
24V AC 350mA AC
115V AC 60Hz
24V AC 350mA AC
100V AC 50/60Hz
24V AC 350mA AC
11