Replacing The Lamp - AEG DGB3850M Benutzerinformation

28 www.aeg.com
2
2. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
4. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.3 Replacing the charcoal
filter
The charcoal filter must be replaced if
the filter alarm is on.
Refer to the filter notification
in daily use chapter for more
information about function.
WARNING!
The charcoal filter is NON-
washable! The filter cannot
be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Turn the filter counterclockwise (1)
and then pull (2).
1
To mount the filters back follow the steps
in reverse order.
In any case, it is necessary to replace
the filters at least every four months.

4.4 Replacing the lamp

This appliance is supplied with a LED
lamp and separate control gear (LED
driver). These parts can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
1
2