Cervelo S3 DISC Betriebsanleitung Seite 27

5. To trim fork steerer, use only a saw suitable for cutting carbon, and
a cutting guide.
6. Carefully sand a bevel to the inside of the cut end of the steerer
tube to fit the insert.
7. Dry fit insert to check that it is flush with the cut end of the steerer
tube.
8. Use isopropyl alcohol to clean the inside of the steerer tube and
the outside of the insert.
9. Fully mix the two-part epoxy and apply to the outer surface of the
insert with the wooden mixing stick.
10. Slide the insert into the steerer while rotating it slowly until the
flared end sits flush with the top of the steerer.
11. Wipe away any excess glue from the outside surface of the steerer
tube with the isopropyl alcohol wipe.
12. Set the fork aside and allow it to sit undisturbed for the full curing
period.
Do not attempt to fit the fork into a bike prior to the completion of
the full curing period.
Improper cutting of the steerer tube could cause a failure that
results in severe injury or death.
Insert should be flush
with cut end of the
fork steerer tube
4