The test device operates with a factory-calibrated sensor.
NOTE: The test device must be checked or recalibrated following exposure of the sensor to non desorbing contamination or replacement of the sensor.
Display [2]
All application-specific functions are shown on the touchscreen display. The function is activated by pressing the corresponding point on the display.
NOTE: Do not use any pointed or hard objects to operate the display. This can cause irreversible damage to the display, e.g. through scratching or breakage. The display should be
operated with fingers only.
ON/OFF button [3]
Press the ON/OFF button to switch the unit on or off.
Holder bracket [4]
The holder bracket is located on the back of the device. The holder bracket is used to attach the device to the air vent slit of the air out-let openings of an air conditioning system in
the vehicle interior.
Batteries and plug-in charger
Rechargeable batteries are fitted inside the device. The operating time with batteries fully charged is approx. 8 hours.
Scope of delivery:
1.
airco well
sensor
®
2.
Charger with USB cable
3.
Sensor Test Spray (optional)
4.
Operation manual
5.
Case
FINAL Bediensanleitung_Sensor_verbessert II.indd 19
FINAL Bediensanleitung_Sensor_verbessert II.indd 19