Device Description; Intended Use; Likely Misuse - Tunap Airco well Sensor Bedienungsanleitung

Device description

The airco well® sensor is designed as a test device. The airco well® sensor is used to carry out a load test of the air outflow before and after cleaning of a vehicle air conditioning
system. For this, the unit is placed on the ventilation grille. An additional sensor holder with item no. 1400990 can be ordered from TUNAP. A sensor installed inside the device tests
the air outflow for load as the air passes through the unit.
The test reading is shown in the display. The display also shows error detection, battery level and charging messages.
The test device can be connected to a computer via a USB cable, allowing the test results to be printed out.
The power supply is via a factory-installed rechargeable battery. The battery is charged with a standard charger (Micro-USB, included).
The guarantee of the Sensors is 12 months. Contamination of the sensor and the battery package are excluded.

Intended use

The airco well® sensor is used to test the load of the air flowing out of the air vents before and after cleaning of a vehicle air conditioning system. The test device is designed to be
operated and used for its intended purpose by qualified and trained personnel in service workshops in accordance with these instructions and all applicable local safety regulations.
Any form of use different from or beyond the above constitutes use for other than the intended purpose. No liability will be accepted for any resulting damage.

Likely misuse

Improper use and/or operation may result in hazards for the user or third parties or damage to the device.
The following situations are considered as likely to constitute misuse:
• Commissioning, operation and maintenance of the test device by non-qualified personnel, without having read and fully understood this manual.
• Non-observance of the instructions regarding transport and storage of the test device.
• Use of the test device in a potentially explosive environment.
• Use of the test device in a damp environment or in water.
• Use of the test device outside the technical specification and limits.
• Use of the test device as a measuring instrument according to the Measuring Instruments Directive.
• Use of the test device for direct personal protection.
• Use of the test device in an environment exposed to hazardous substances without observing the applicable safety regulations.
• Use of the test device where specific hygiene requirements apply, e.g. in the food, beverage and luxury food industry, pharmaceu-tical industry and/or biotechnology.
• Use of the test device for applications which directly or indirectly involve human life or health (e.g. medical technology).
• Opening the test device, carrying out unauthorized conversions or technical changes to the device.
• Use of non-approved spare parts.
• Replacement of sensors without recalibration.
18
FINAL Bediensanleitung_Sensor_verbessert II.indd 18 FINAL Bediensanleitung_Sensor_verbessert II.indd 18 22.03.2021 10:42:52 22.03.2021 10:42:52