GreenWorks G40CS30 Bedienungshandbuch Seite 10

Problem Possible cause
The motor runs
The chain is
and the chain ro-
blunt.
tates, but the
chain does not
The chain is in
cut.
the incorrect di-
rection.
The chain is tight
or loose.
The machine
does not start.
The chain brake
is engaged.
The machine
and battery are
not connected
correctly.
The battery level
is low.
The lock out but-
ton and the trig-
ger are not push-
ed at the same
time.
The battery is
too hot or too
cold.
English
Solution Problem
Sharpen or re- The motor runs,
place the saw but the chain
chain. does not cut cor-
rectly, or the mo-
Turn the chain
tor stops after
loop to the other
around 3 sec-
direction.
onds.
Adjust the chain
tension.
Pull the chain
brake in the di-
rection of the
user to disen-
gage it.
Make sure that
the battery re-
lease button
clicks when you
install the battery
pack.
Charge the bat-
tery pack.
1. Push the
lock-out but-
ton and hold
it.
2. Push the trig-
ger to start
the machine.
Refer to battery
and charger
manual.
9
Possible cause Solution
Release the trig-
The machine is
ger and start the
in the protection
machine again.
mode to protect
Do not force the
the PCB.
machine to cut.
Charge the bat-
tery. Refer to the
The battery is battery and
not charged. charger manual
for correct charg-
ing procedures.
Lubricate the
chain to de-
crease the fric-
tion. Do not let
The chain is not
the guide bar
lubricated.
and the chain
operate without
sufficient lubri-
cant.
Cool the battery
Incorrect battery pack until it de-
storage tempera- creases to the
ture ambient temper-
ature.
EN