Initialisation - Assmann MONTEVO HOME Benutzerinformation

Initialisation

Setting the reference points
The desks may have to be re-initialized when set up for the first
time, following a power failure or after being disconnected from
the mains supply.
Initialisation hand switch SKQ
Read through the following steps carefully before starting so that
the initialization procedure. As soon as you connect the sit-stand
table to the power grid, three dashes „- - -" light up in the display.
To start initialisation, move the desk into its bottommost position.
1. To do so, press the button on the bottom of the hand control
and the rocker switch to the direction DOWN ▼ at the same
time and only release them when the table has moved
completely downwards and has made a slight movement
upwards again and the table no longer moves.
2. The desk is now initialised and can be set to the user's cus-
tom height.
If the button is released too soon, this causes a desk malfuncti-
on. If the button was released early by accident, you must repeat
the process.
+
M O N T E V O H O M E
Please note:
Ensure that no rolling cabinets or other solid objects are blocking
the desk from reaching the lower end point. The desk is outfitted
with an non-collision feature by default which automatically stops
it if there are any obstructions and causes it to move in the oppo-
site direction. This can be misinterpreted as moving to the lowest
position. No initialization is taking place here and the procedure
must be repeated from the beginning.
Please note:
If the control keys are released when moving to the reference
point before the procedure is complete, the reference run will be
interrupted and the entire initialisation procedure must be repea-
ted from the beginning.
I N S T R U C T I O N S H E E T
17