Fitting The Roof Tent To Your Roof Rack Or Roof Bars; Set Up Instruction - Reimo Wallaby 2 Benutzerhandbuch

4. FITTING THE ROOF TENT TO YOUR ROOF RACK OR ROOF BARS

Attention! Please pay attention to the maximum permissible roof load
registered in the user manual of your vehicle!
1. Lift the tent onto the vehicle.
2. Place the 8mm bolt into the slide plate. Slide the plate and bolt into the mounting extrusion.
See figure 2.
3. Attach the roof tent to your roof rack or roof bars in four places as per figure 3.
4. Use 2 bolts and 2 slide plates with the base plate to hang the bar. 1 set per corner.
5. Prior to tightening all the nuts, ensure that your roof tent is centered (side to side) on the
roof of your vehicle and that the mounting points (as far as possible) are symmetrically
positioned near each corner of the tent.
figure 2

5. SET UP INSTRUCTION

1. Release the hold down velcro straps on
each side of the tent.
2. Remove the cover from the tent by open-
ing the zip on three sides and pulling the
cover downwards. Remove the cover or
leave it hanging on the piping rail.
3. Slide out the ladder until the
locking pins engage.
figure 3
Step 1
11
DE
EN
IT
ES
FR
FI
DK
SE
Step 2
Step 3