VEVOR VS5500 Handbuch Seite 18

Air has re-entered into the bag after being sealed.
1. Leaks along the seal which can be caused by wrinkles, debris crumbs, grease or
liquids. Reopen bag, wipe the top inside of the bag and smooth it out along the
sealing strip before resealing.
2. The release of natural gases or fermentation form foods (such as fresh fruits
and vegetables) may occur. Open bag, if you think food has begun to spoil, and
discard food. Lack of refrigerator or fluctuating temperatures in the refrigerator can
cause food to spoil. If the food which is not spoil. Consume food immediately.
3. Check the bag for a puncture or hole which may have released the vacuum. Do
not vacuum packaging hard items with sharp points (like bones or cracks of nut
shell). Cushion sharp edges in the contents of the bag with paper towels.
The bag melts:
Should sealing strip or sealing element be overheat and melt the bag, it may be
necessary to lift the lid and allow sealing strip or heating element to cool for a few
minutes.
The canister will not vacuum:
1.Make sure the adaptor was well connected both to the appliance and the canister
firmly.
2.Check if the knob of the canister was on the position of "seal".
3.Press the lids OR on the hose adaptor at the very beginning of vacuuming to avoid
leaking from the cover seal...
4.Check if there are significant damages or smashes, if yes, change it for a new one.
5.Check the function of the vacuum sealer.
6.Make sure the rim of the canister is clean enough. If all the above situations are
excluded, please contact with the appointed service agency.
16