Cleaning Surfaces; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL TC-BG 150 B Originalbetriebsanleitung

6.3 Cleaning surfaces

Important! You can use the brushing wheel (6) to
clean castings, fi les, bolts, threads or other sturdy
items. The brushing wheel can also be used to
remove rust or old paint from surfaces.
•
To clean the workpiece in question, place
it on the workpiece support (7) and slowly
guide it at the desired angle towards the brus-
hing wheel (6) until it makes contact.
•
For the best possible results move the work-
piece back and forth while applying slight
pressure.
Caution!
If the grinding wheel / brushing wheel becomes
jammed during operation, move the workpiece
away and wait until the machine reaches its top
speed again. You might need to guide the workpi-
ece towards the grinding wheel / brushing wheel
with less force.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
Anl_TC_BG_150_B_SPK13.indb 21 Anl_TC_BG_150_B_SPK13.indb 21
GB
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8.4 Transport
Transport the machine by lifting it by the motor
housing (10) or the base plate (9) only. Never use
the safety devices such as the safety glass (2),
spark defl ector (3/4) and workpiece support (7)
for handling or transporting purposes.

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 21 -
17.11.2022 14:36:45 17.11.2022 14:36:45