Battery Status - Kress KG346 Serie Bedienungsanleitung

3. CHARGING YOUR BATTERY PACK (See
Fig. H)
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit. Each
battery must be fully charged before the first use.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
NOTE: Always fully charge the two batteries at
same time. More details can be found in charger's
manual.
H
4. TO REMOVE OR INSTALL BATTERY PACK
(See Fig. I)
Depress the battery pack release button to remove
the 2 battery packs from your tool. After recharging,
insert the 2 battery packs into the battery ports. A
simple push and slight pressure will be sufficient until
a click is heard. Check to see if the battery is fully
secured.
NOTE:
• When removing the battery pack, hold it firmly
to avoid dropping and injury.
• This machine will only run when 2 batteries are
installed. It is recommended to use the same
two batteries and charge the two batteries at
the same time.
• When you use two batteries with different
power, the machine will only run to the lower
common denominator.
I
5. POWER INDICATOR LIGHT (See Fig. J)
IMPORTANT:
When only one light is illuminated, your battery is
overly discharged, even though the machine may
still be capable to work. Continuing to operate
your machine with the battery in this discharged
condition may reduce the life and performance of
your battery.
When no light are illuminated, at least one battery
is not fully installed or battery may be defective,
please double check the batteries are fully seated
into position.
J

BATTERY STATUS

• Before starting or after use, press the button
beside the power indicator light on the machine to
check the battery capacity.
• During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
• For the machine with 2 battery packs with
different power, the power indicator light displays
the battery condition with the lower one of the two
batteries.
Battery indicator
light status
Five green lights The two batteries are in a
( ) are highly charged condition.
illuminated.
Two, three or four The two batteries have a
green lights are remaining charge. The more
illuminated. lights are illuminated, the
more battery capacity.
Only one green The battery level of at least
light ( ) one battery pack is very low.
is illuminated. Please check and charge the
battery pack.
No light is At least one battery is not fully
illuminated. installed or battery may be
defective.
Battery condition
EN
13