Assembly & Operation - Kress KG346 Serie Bedienungsanleitung

Do not burn
Batteries may enter water cycle if
disposed improperly, which can
be hazardous for ecosystem. Do
not dispose of waste batteries as
unsorted municipal waste.
Unlock
Lock
ASSEMBLY
WARNING! Do not install the battery pack
before it has been completely assembled.
Always use gloves when handling the chain.
CHAIN AND GUIDE BAR ASSEMBLY
1. Unpack all parts carefully. Remove the chain cover
EN
by turning the chain tensioning knob in a counter-
clockwise direction. (See Fig. A1)
A1
2
2. Place the Chainsaw on a solid, level surface.
3. Use only genuine Kress chains or those
recommended for Guide Bar.
4. Slide the chain in the slot around the guide bar.
Ensure the chain is in correct running direction by
comparing it to the chain icon on the guide bar, or
referring to the chain direction symbol found on
the saw body. Ensure the bar tensioning plate is
facing outward. (See Fig. A2)
10
A2
5. Fit the chain onto the drive sprocket, so that the
fastening bar bolt and the two bar locating tabs on
the bar pad fit into the keyway of the opening on
the guide bar. (See Fig. B1, B2)
B1
B2
1
6. Assure all parts are seated properly and hold
chain and guide bar in a level position. Make sure
the drive links are fully seated in the drive sprocket
(See Fig. C1), avoiding a kink as shown in Fig. C2.
If kink occurs, pick up on the chain at the guide
bar just ahead of the kink and then pull the kink
out.
NOTE: Chain should rotate freely and be free of
kinks.
24
2
1