Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.1.2 s
tArting the mAchine
Before turning on the machine, make sure to re-
move wrenches and adjusting tools.
When turning on, hold the flexible shaft extended.
During operation make sure that the flexible shafts have
large bend radius.
Before starting the machine, hold the hand tool against
turning!
Five different speeds can be stored under the «1-5» keys
for each threaded connection. The speed of the «F» key
applies to both threaded connections.
If not all of the «1-5» keys are required, a memory location
can be set to the value «zero».
If any key (except the «+/-» key) is pressed while the ma-
chine is running, an immediate stop is made. The display
flashes. Before restarting, the key with the correct speed
must first be pressed.
Press the main switch (1) of the machine.
Speed display (2) flashes and shows last speed and
memory location.
Select desired memory location for keys «F, 1, 2, 3, 4, or
5» (3).
Speed display (2) is on.
Use the «-/+» keys (4) to set the speed.
This operation can be performed for all memory locations.
To initiate the start, the «run (5) key must be pressed with-
in 30 seconds after selecting the memory location or set-
ting the speed. If the start process is not activated in time,
the display starts flashing and the start can no longer be
executed.
The speed can be changed during operation with the
«-/+» keys (4).
30
3.1.3 m
Achine stop
Press the «stop» key (1). Hold the hand piece firmly. The
machine brakes to zero speed. Speed display flashes (2).
Switch off the main switch (3).
3.1.4 s
hAft receptAcle
On production stop place shaft in the appropriate shaft
receptacle.
On prolonged interruption of work detach shafts
and hand tools and store shaft straight.
When the tool is not being used unplug the power
connector.
3.2 A
BrAsiVes
Speed rating on the abrasive is equal to or greater
than the speed adjusted on the machine.
Exclusively abrasives from the SUHNER catalog
are to be used.
Threat and store abrasives appropriately.
Damaged abrasives discs may not be used.
Always switch off the machine before changing the tool
or abrasive.
3.3 «s
»
tep
sAfety deVice
The «step» safety device services for stopping the hand
tool drive.
(
)
option
Werbung
Inhaltsverzeichnis
