Fein SCS4.8-25 Anweisungen Seite 13

OBJ_BUCH-0000000012-001.book Page 13 Friday, January 28, 2011 8:56 AM
Original Instructions for Dry Wall Screw Gun. en
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise
there will be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Observe the information in the adjacent text!
Confirms the conformity of the power tool with the directives of the European Commu-
nity.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be
sorted separately for environment-friendly recycling.
Product with double or reinforced insulation
Low speed
High speed
Reduce torque
Increase torque
Character Unit of measure,
international
P W
1
P W
2
U
V
f
Hz
n /min
0
n /min
1
M... Nm
inch
mm
kg
L dB
pA
L dB
wA
L dB
pCpeak
K...
2
a
m/s
2
a
m/s
h
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
Unit of measure,
national
W
W
V
Hz
rpm
rpm
Nm
inch
mm
kg
dB
dB
dB
2
m/s
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
Explanation
Power input
Output
Rated voltage
Frequency
No-load speed
Speed, full load
Torque
Hexagon socket tool holder
Screw diameter
Weight according to EPTA-Procedure 01/2003
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to EN 60745
(vector sum of three directions)
Vibrational emission value (screwdriving)
Basic and derived units of measure from the inter-
national system of units SI.
en
13