DJI AVATA Schnellstartanleitung Seite 10

1. Lock Button
EN
Takeoff: press twice to start the aircraft motors and then press
and hold to make the aircraft take off. The aircraft will ascend to
approximately 1.2 m and hover.
Landing: while the aircraft is hovering, press and hold to land the
aircraft and stop the motors.
Brake: press during flight to make the aircraft brake and hover in
place. Press again to unlock the attitude.
2. Joystick
Toggle up or down to make the aircraft ascend or descend. Toggle
left or right to make the aircraft horizontally move left or right.
3. Mode Button
Press to switch between Normal and Sport mode. Press and hold to
initiate RTH.
4. FN Dial
Press the dial to open the camera settings panel in the FPV view of
the goggles. Scroll the dial to navigate the settings menu or adjust
the parameter value, then press the dial to confirm the selection.
Press and hold the dial to exit the current menu.
Use the FN dial to control the camera tilt before takeoff or during
RTH and landing. Press and hold the FN dial from the FPV view and
then scroll up or down to tilt the camera. Release the dial to stop
the camera tilt.
5. Shutter/Record Button
Press once: take a photo or start/stop recording.
Press and hold: switch between the photo and video modes.
6. Accelerator
Press to fly the aircraft in the direction of the circle in the goggles.
Push forward to fly the aircraft backward. Apply more pressure to
accelerate. Release to stop and hover.
1. Lock 按键
CHS
起飞：双击启动飞行器电机，然后长按，飞行器自动起飞至约 1.2 m 并
悬停。
降落：悬停时长按，飞行器自动降落至地面并停止电机。
刹停：飞行时，短按可使飞行器刹车悬停。再按一次解除姿态固定。
6
4
1
4
6
2
3
5