Installation Notes - BEMKO SES05WH/BL-A Bedienungsanleitung

INSTALLATION NOTES

Avoid mounting the detector near heat sources, such as heating vents, air
conditioning units, light etc.
Avoid pointing the detector towards objects that may move in the wind, such
as curtains, tall plants etc.
Avoid pointing the detector towards objects with highly re ective surfaces,
such as mirrors etc.
CONNECTION
Warning! Danger of death through electric shock!
- must be installed by professional electrician
- disconnect power source
- cover or shied any adjacent live components
- check power supply is disconnected
The wires come in and out from
the bottom
Please move the upper cover with anti-clockwise whirl as per the diagram on the right.
Connect the power and the load according to the connection-wire diagram.
Fix the bottom on the selected position with the in ated screw.
Install back the upper cover on the sensor, then you could switch on the power and test it.
TEST
Turn the TIME knob anti-clockwise on the minimum(10s).Turn the LUX knob clockwise on the maximum
(sun).
Switch on the power; the sensor and its connected lamp will have no signal at the beginning. After
Warm-up 30sec, the sensor can start work .If the sensor receives the induction signal, the lamp will turn
on. While there is no another induction signal any more, the load should stop working within 10sec±3sec
and the lamp would turn o .
Turn LUX knob anti-clockwise on the minimum (3). If the ambient light is more than 3LUX, the sensor
would not work and the lamp stop working too. If you cover the detection window with the opaque
objects (towel etc), the sensor would work. Under no induction signal condition, the sensor should stop
working within 10sec±3sec.
NOTE: When testing in daylight, please turn LUX knob to
between lamp and sensor should be 60cm at least.
MOST COMMON PROBLEMS AND SOLVING WAYS
The load do not work:
1) Please check if the connection-wiring of power and load is correct.
2) Please check if the load is good.
3) Please check if the working light sets correspond to ambient light.
The sensitivity is poor:
1) Please check if there has any hindrance in front of the detection
window to a ect to receive the signal.
2) Please check if the ambient temperature is too high.
The wires come in and out from
the side
(SUN) position, otherwise the sensor lamp could not work! If the lamp is more than 60W, the distance
3) Please check if the induction signal source is in the detection elds
4) Please check if the installation height corresponds to the height
showed in the instruction.
5) Please check if the moving orientation is correct.
The sensor can not shut o the load automatically:
1) Please check if there is continual signal in the detection eld.
2) Please check if the time delay is the longest.
3) Please check if the power corresponds to the instruction.