Initialization Of The Built-In Aircloud Home Module - Hitachi RAK-DJ18PHAE Bedienungsanleitung

Initialization of the Built-in airCloud Home Module

Reset the internal settings (restore the factory settings) by remote controller.
Please note that the configuration will be cleared and pairing procedure will be required to do again to
use the built-in airCloud Home module.
(1) Press Mode key and ON Timer key simultaneously, pointing
the remote controller towards the air conditioning unit.
(2) Make sure Wi-Fi LED on Indoor unit flashes 4 times repeatedly
for about 20 seconds (LED is turning off between 2 sequences
of 20 seconds).
(3) Restart the unit (turn power OFF during 1 minute, then turn
power ON again) and check that the Wi-Fi LED is blinking 3
times.
If Wi-Fi LED is indeed flashing 3 times, pairing mode is well
activated and factory settings have well been restored.
Status Indicator (LED Indicator may light up while the air conditioner is turned off)
Wi-Fi Lamp
LED OFF
LED ON
LED flashes 3 times
LED flashes 4 times
LED flashes 5 times
LED flashes with 4sec ON/1sec OFF Router connection error.
LED flashes with 4sec ON/3sec OFF Cloud connection error. (Error detection time: approx 30 mins.)
Note:
Please try to power OFF/ON your air conditioner from mains switch when an error occurs.
*"Wi-Fi" is a trademark or registered trademark of the "Wi-Fi Alliance".
Corresponding Status
• Pairing time out occurs (after 10 mins.) & configured router not detected.
• Air conditioner is not plugged in.
• Built-in airCloud Home module and the air conditioner is not connected.
• The connection between the Built-in airCloud Home module and the router is
completed.
• The operation can be conducted through smartphone.
Waiting to connect to the Wi-Fi router using AP mode.
Restoring factory setting procedure has started.
Communication error between air conditioner & Built-in airCloud Home module
(Error detection time: approx 24 mins.)
Indoor Unit Indications: Wi-Fi LED
- 12 -
Mode On Timer
Wi-Fi Lamp (Blue)