Operation Via Remote Control - Opera CLARO Benutzerhandbuch

OPERATING INSTRUCTIONS

1. Operation via remote control

Connect the remote control to the hood
Connect the hood to the mains. While LED (5) is on, press key (A) on the remote control.
LED (5) will blink for a while, after that the remote control is connected to the hood.
ON / OFF (A)
To switch on, press key (A). The fan starts at power level 1 and
LED (1) shines. To switch off, press key (A) again.
Increase fan power (B)
The fan power increases by one power level each time the button is pressed. On the
operation display the LED relative to the current level is switched on.
Intensive level
At level 4 the maximum fan power is reached. On the operation display LED (4) blinks. After
5 minutes the fan power level automatically switches back to level 3.
Reduce fan power (C)
The fan power decreases by one power level up to power level 1 with each press.
Timer
By keeping key (A) pressed for some second the automatic fol low-up timer is activated and
the current power level LED blinks. The cooker hood switches back from the current level
one level down at 5 minute intervals and switches off definitively after maximum 15 min.
Filter saturation indicator (F)
(automatic display when switching off the fan after 15 operating hours)
The filter saturation indicator will be reset by pressing the key (B) (~10 sec.) until LED (5)
turns off. ( only possible when the fan is switched off ! )
Illumination (D/E)
Press the key (D) to turn on the hob light. Press key (E) to switch
it off.
Illumination dimming function
By keeping key (D) pressed, the illumination intensity rise. If key (E)
is keep pressed, the illumination intensity goes down.
Colour temperature setting
The colour temperature of the LED hob lighting can be infinitely
adjusted between 2700K and 6500K.
Press and hold key (C) to adjust, the LEDs start
to change the colour temperature. When the desired setting is
reached, release the button, the colour setting is saved.
( LED (F) )
20