Filter Replacement; Air Quality Indicator - ECG AP1 Compact Pearl Bedienungsanleitung

Filter replacement

Take care of your health and change the filter regularly.
The filter life cycle counter is set to approx. 2000 hours. After the device counts these hours of operation, the
"Filter Counter" indicator starts flashing and a beep sounds. Change the old filter for a new one and press the
"Filter Counter" icon for about 3 seconds. The audio signal is switched off and the light is continuously lit white.
Note: Always remember to remove the packaging before inserting the filter into the appliance.
Preparing the aroma sponges
You can add a few drops of essential oil on the sponges. Then when the appliance will be in operation, it will
emit clean air enriched by the aroma of oil.
USE
Turning the device on
After connecting to power, a beep sounds and all the indicators flash 2 x and then go out, only the power
indicator light ("Turning on / off") remains red and the appliance enters standby mode.
Press the "On / Off" button to start the appliance automatic mode. The appliance will flash colors after it is
turned on. The air quality is checked at that moment. The backlight color remains permanently on after a few
seconds. The backlight color indicates the air quality.

Air quality indicator

Blue - Excellent
Green - Good
Purple - Bad
Red - Very bad
Using the application
ATTENTION:
If you change the name of your home WiFi network or password, you will need to restore connection with your
appliance.
• The application supports the operating system version of the IOS 9.0 and higher, Android 6.0 and higher;
in general, the system version can be checked using setting in a mobile phone or tablet.
• This model supports WiFi network security with WEP, WPA, WPA2, WPA3, AES and TKIP.
• Configuring the appliance to access the network requires a 2.4 GHz WiFi network, the 5 GHz frequency
range is not currently supported.
Filter cover handle
Aroma sponges
Filter
9