Control Panel Overview - ECG AP1 Compact Pearl Bedienungsanleitung

CONTROL PANEL OVERVIEW

E
1. Setting the air flow speed
Press the button sequentially to switch between
low (LOW) and high (HIGH) airflow speed and
between (AUTO) and (SLEEP) mode for the
appliance's night mode.
Note: Color backlight turns off in Night mode
(Sleep). In (AUTO) mode, the air velocity changes
automatically according to the air quality in the
room.
Resetting the filter life counter
2.
Press and hold the button to reset the counter of
the remaining filter life cycle. Use only after you
replace the filter.
INSTALLATION
WARNING:
Before using the air purifier, remove the filter cover in the appliance according to the instructions below:
Replacement of filter and aroma sponges
Remove all packaging from the appliance before first connecting the appliance, both from outside and from
the inside. The filter is packaged. Hold the unplugged so that you can open the lower cover lock. On the bottom
of the appliance and the lid are shown locks for easier handling. Aromatic oil sponges are located in the filter
cover. Return the filter before use and lock the lid carefully.
Risk of property damage: The appliance may only be used if it is properly and completely assembled.
8
3. On / Off
Press to turn the appliance on/off. In stanby mode
the light is red, when on, the indicator lits white.
4. Timer function
By pressing the button, you can set the timer
functions to 1, 2, 4 or 8 hours.
Ionizer
5.
Press briefly to turn on or off the air ionization.
When the unit is switched on, ionization is on; the
ionization icon is on the display. After pressing
the button again, the icon disappears from the
display. To turn it on again, press the place on the
display where the icon was before being turned
off.
A
B
C
D