| TROUBLESHOOTING
PROBLEM
The LED on the front
panel is OFF.
The Tube output stage is
not playing.
With EXTREME care use ONLY water or detergents for delicate surfaces with a very soft
cloth to sweep dust and remove stains.
Any acid or not extremely soft cloth will irreversibly damage the unit fine aesthetic. Do not
use alcohol.
CAUSE
|
The POWER CORD is
damaged or not plugged
in.
|
The MASTER SWITCH is
OFF.
|
The fuse is blown.
|
The unit is heating.
CLEANING THE UNIT
7
SOLUTION
|
Ensure that the POWER
CORD is not damaged
and connect it properly.
|
Press the Power ON/
Standby button.
|
Turn ON the MASTER
SWITCH on the rear panel
of TUBE-1012.
|
Substitute the fuse with
one of the same value.
|
Wait for the unit to be
ready - about 30 sec.