Gold Note TUBE-1012 Bedienungsanleitung Seite 12

| INSTALLATION
With 12 or 6 tubes, our Valve Output Stage
is the best way to enhance your system for
improved realism and musicality.
Our proprietary Totem-Pole Output Stage
design, with six independent audio stages
per tube, guarantees ultra-wide bandwidth
response and ultra-low distortion to deliver
the purest audio signal ever.
USING TUBE WITH GOLD NOTE
UNITS
1
Connect the TUBE to the power outlet
using the AC power cord included. The
AC power socket is located on the rear
panel of the unit.
2
Connect the TUBE to your Gold Note
unit using the GN TUBE connection cable
included. Please ensure to use the TUBE
INPUT connectors located on the rear
panel.
3
If you want the unit to automatically turn
ON/OFF along your other Gold Note
unit in master/slave mode, connect your
other Gold Note unit (master) to the tube
output stage (slave) through the GN LINK
IN connector found on the rear panel.
If you want it to act as the master and
control other Gold Note units, use the
GN LINK OUT connector instead.
4
Turn to ON the MASTER SWITCH on the
rear panel.
5
The status LED will turn ON/OFF as it is
now controlled by the other Gold Note
unit. When ON, the Power Led is blue as
the TUBE INPUT is selected.
Thanks to new audio inputs on the rear
panel our valve output stages can be
connected with up to two sources at the
same time using the TUBE INPUT for the
Gold Note sources and the LINE INPUT for
other manufacturers. The input can be easily
selected from the front panel for maximum
convenience and ease of use.
USING TUBE WITH OTHER UNITS
1
Connect the TUBE to the power outlet
using the AC power cord included. The
AC power socket is located on the rear
panel of the unit.
2
Connect the TUBE to your other units
using the LINE INPUT connectors located
on the rear panel.
3
Turn to ON the MASTER SWITCH on the
rear panel.
4
Press the Power On button and then
press once the IN button located on the
front panel to select the LINE INPUT as
the input - the LED colour will change
from blue to green.
5
Wait for around 30 seconds to allow the
valves to warm up.
5