Cleaning; Cleaning The Supernova Led - MICRO-EPSILON ELTROTEC SuperNova LED Betriebsanleitung

Cleaning

6.
6.1
The SuperNova LED is not waterproof. The SuperNova LED is rated for slight water contact and mild deter-
gent cleaning solutions only. It must not be immersed in water or cleaning solutions.
Avoid a rough cleaning of the light source.
NOTICE
> Damage of the light source
Failure to comply with the following may result in damage to the SuperNova LED and will void the product
warranty.
i
- Only use water with a mild detergent such as a nonabrasive hand or dish washing soap.
- Do not immerse the SuperNova LED in an ultrasonic cleaner.
- Ensure that the battery hatch door is fully tightened on the O-ring seal to prevent liquid intrusion into the
battery compartment.
- Never use any organic solvents to clean the SuperNova LED, other than isopropyl alcohol.
ELTROTEC SuperNova LED
Cleaning

Cleaning the SuperNova LED

After cleaning, remove SuperNova LED from cleaning solution, dry and store the device in a clean and
dry environment.
Avoid pressing too hard, and allow the alcohol to evaporate before using. A gentle burst of clean dry air
may also help dislodge any foreign particles.
Page 31