Led Charge Indicator; Battery Replacement - MICRO-EPSILON ELTROTEC SuperNova LED Betriebsanleitung

Operation
A full charge on a completely discharged light takes about 3 hours.
5.1.2
- With the light inserted properly in the charging cradle, the red, charge-indicator LED should be lit. It may
- While charging – the LED glows steadily.
- When charged – the LED blinks about once per second.
i
- Temperatures outside this range may cause the charge indicator to temporarily function abnormally.
- It is normal for the indicator to switch between steady glow and blinking as the battery reaches full charge.
- There is no danger of overcharging. The light is designed to be in the charger continuously when not in
5.2
Fig. 5 Remove battery
Replace battery with GLC part number SN-BATT only. The arrangement of the contacts in the light source
NOTICE
precludes the use of other batteries.
> Damage or destruction of the light source or the battery
ELTROTEC SuperNova LED
Slide the LED lamp, handle-first, into the charger, until the contacts snap into engagement, see
see Fig. 3, see Fig. 4.

LED Charge Indicator

take a second or two for the LED to light when the light is first inserted.
Charging temperature is between -7 °C (20 °F) to 46 °C (115 °F). A safety circuit prevents charging
outside the range.
use.

Battery Replacement

Should the rechargeable, lithium-ion battery need replacing, unscrew the tail cap from the light and
remove the battery.
Insert the concentric-contact end of the new battery first and replace the tail cap.
Fig. 2,
Page 28