Storage; General Troubleshooting - Sublue WhiteShark Navbow+ Bedienungsanleitung

2

Storage

If the device will be idle for a long time, please note that the MixPro and the battery
should be stored separately in the package; and please observe the following
directions.
1. Ensure that the device is stored in a cool and ventilated place, above 0°C and below
45°C where the humidity is 65±20％RH.
2. Avoid direct sunlight.
3. Keep it away from heat, fire, and children's reach.
4. Keep it away from devices that may generate strong magnetic fields.
5. Take out the device at least once a month and run it for about 10 seconds to
prevent corrosion caused by changes in the storage environment.
28

General Troubleshooting

Fault
1. Turn off the device
2. Check if the propeller is entangled in foreign matter
Propeller stuck or
3. Follow the instructions in the "Maintenance" chapter to
abnormally running
clean the underwater scooter
4. Contact Sublue or an authorized service organization
Damaged or
Contact Sublue or an authorized service organization
swollen battery
1. Check for damage around the battery contacts
2. Check the device's sealing gasket for damage or
protrusions
Battery contact is
3. Check the battery sealing surface corresponding to
corroded
the sealing gasket for scratches or protrusions
4. If the corrosion is slight, clean it with a dry cloth
5. Contact Sublue or an authorized service organization
1. Please fully charge the battery and install it before restart
Failure to power on
2. Contact Sublue or an authorized service organization
1. Check if it is in one-hand operation mode or
speed-change operation mode
Abnormal operation
2. Try to reboot the device
3. Contact Sublue or an authorized service organization
1. Please power off the device and take out battery
Failure Code: ER00
2. Contact Sublue or an authorized service organization
Solution
29