Fitting The Base Platter - T+A G10 Betriebsanleitung

1. Remove the acrylic platter from the metal platter by
pressing on the metal centre with both thumbs and
pulling on the edges of the acrylic platter using your
fingers.
2. Oil the bearing in the platter thoroughly using the
syringe supplied.
3. Place the bearing ball in the depression in the pivot
shaft and oil it well using the syringe.

Fitting the base platter

Important note concerning subsequent stages of
assembly:
Please take great care to avoid oil getting onto the drive
belt.
4.
5.
6.
7.
8.
9.
10. When the platter has reached its final position,
26
Place the drive belt around the inside core of the
platter, as shown in the illustration.
Draw the drive belt through the large opening in the
platter and onto the top surface. Hold it in that posi-
tion with one finger.
Hold the platter exactly horizontal, and carefully
lower it vertically onto the pivot shaft.
Rotate the platter gently and press it down using no
more than light pressure until it seats correctly. The
platter will slowly sink down the bearing. This will last
a certain period of time (up to 30 min.).
Lay the drive belt round the drive pulley, working
through the platter opening.
If the platter does not seat fully, wait for it to settle
onto the bearing ball. This may take some time, as
the oil has to be pushed up through the very narrow
bearing clearance gap.
check that it can be rotated easily by hand.