T+A G10 Betriebsanleitung Seite 34

Many problems have
correspondingly simple solution. The following section
describes a few difficulties you may encounter, and the
measures you need to take to cure them. If you find it
impossible to solve a problem with the help of these
notes please disconnect the unit from the mains and
ask your authorised  specialist dealer for advice.
Problem: Machine does not switch on (LED
stays dark).
Mains lead not connected correctly.
Cause:
Check connection, push plug in firmly.
Remedy:
Problem: Fluctuating sound.
Cause 1: Bearing not oiled sufficiently.
Oil the bearing: see section entitled
Remedy:
'Fitting the platter'.
Cause 2: Drive belt worn or exhausted.
Replace drive belt.
Remedy:
Cause 3: Drive belt oily.
Clean drive belt, pulleys and / or platter
Remedy:
with methylated spirit on a cloth.
Caution:
Keep methylated spirit away from the
acrylic parts, as they could crack.
See also the section entitled 'Care of the
machine'.
Problem: Unwanted hum
The G10 or a device connected to it is
Cause:
not earthed.
Connect a separate chassis earth wire
Remedy:
(G10: earth terminal 'GND' to earth
clamp on the machine to which it is
connected).
Trouble shooting
a simple cause and a
34