Fitting The Base Platter - T+A G 1260 R Betriebsanleitung

Fitting the base platter

Important note concerning subsequent stages of assembly:
 
 
Please take great care to avoid oil getting onto the drive belt or the belt pulley.
Take care to avoid any dirt soiling the platter bearing.
1. Withdraw the belt pulley (
platter spindle.
2. Remove the transport immobiliser (
3. Thoroughly oil the platter spindle and the bearing indentation using the oil
syringe supplied.
4. Replace the platter spindle in the bush, turning it and lightly pressing it
down at the same time. Please take care to keep the spindle exactly
vertical; the spindle should slide smoothly into the bush.
5. The belt pulley must be pushed down as far as possible; the belt pulley will
slowly descend on the spindle. Wait until the point of the bearing makes
contact with the bottom of the bush.
Note:
   
It may take some while for all the air to escape from the bearing, and the
spindle to take its proper place in the bush, since the clearance in the bearing
is extremely slight. Please allow some time for this (up to thirty minutes).
 ) from the platter bearing, complete with the
 
 ).
 
29