Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING AND SAFETY NOTES
• Do not leave the charger unattended while charging. If any malfunction occurs, TERMINATE THE PROCESS AT ONCE and refer
to the operation manual.
• Disconnect the battery if it becomes hot immediately. Allow the battery to cool down before reconnecting.
• Do NOT attempt to charge incompatible types of rechargeable batteries or even dry (alkaline, zinc-carbon) batteries. This
charger is designed to only charge and discharge Nickel-Cadmium, Nickel-Metal Hydride, Lithium-Ion, Lithium-Polymer
(regular and HV), LiFePO4, and Lead-Acid batteries.
• Never attempt to charge or discharge the following types of batteries.
• A battery pack which consists of different types of cells (including different manufacturers)
• Non-rechargeable batteries (Explosion hazard).
• Batteries that require a different charge technique from NiCd, NiMH, LiPo, LiHV or Pb.
• A faulty or damaged battery.
• A battery fitted with an integral charge circuit or a protection circuit.
• Batteries installed in a device or which are electrically linked to other components.
• Batteries that are not expressly stated by the manufacturer to be suitable for the currents the charger delivers during the
charge process.
• Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibration. Never drop it.
• Do not allow foreign objects into the charger.
• The allowable AC input voltage is 100-240 V/50-60 Hz or 11-18 V DC voltage. DO NOT try to feed the charger simultaneously
using the AC and DC input.
• This charger and the battery should be put on a firm level, heat-resistant, non-flammable and nonconductive surface. Never
place them on a car seat, carpet or similar.
• Keep all the inflammable volatile materials away from operating area.
• Do not cover the air intake holes on the charger as this could cause the charger to overheat.
• Make sure you know the specifications of the battery to be charged or discharged to ensure it meets the requirements of this
charger. If the program is set up incorrectly, the battery and charger may be damaged .It can cause fire or explosion due to
overcharging.
• Do not attempt to charge batteries at excessive fast charge currents. Check with your battery manufacturer for the maximum
charge rate applicable to your battery.
• Do not use automotive type battery chargers to power the charger.
• Do not disassemble the charger.
• This appliance is not intended for use by young children or uninformed persons unless they were adequately supervised by a
responsible adult person to ensure that they can use the appliance safely.
SPECIFICATION
AC Input Voltage
DC Input Voltage
Battery Types/Cells
Charge Current
Charge Wattage
Discharge Current
Discharge Wattage
Balance Current
PC Link
Dimensions
Weight
100-240 V/50-60 Hz
11~18 V
1-6 cell LiPo/LiIon/LiFe, LiHV
1-16 cell NiCd/NiMH
2-24 V Pb
0.1-10.0 A
DC: 2x 100W
AC: CH1+CH2 max. 100W (adjustable power distribution 100:0~50:50~0:100 W)
0.1-5.0 A
2x 10 W
500 mA/cell
Micro-USB port for firmware update
135x105x58 mm
550 g
3
Werbung
