How To Use The Air Compressor Function - Lokithor Aw401 Bedienungsanleitung

b. Connect the positive and negative of the clamps to
the positive and negative of the car battery respectively,
and make sure the connection is good;
c. At this time, the green light on the main interface will
flash, and the voltage of the Jumpstarter in parallel with
the car battery will be displayed. After entering the start
mode, if you want to only check the voltage of the car
battery, short press the "Power" button to exit the start
mode, the Jumpstarter will enter the measurement
mode, and then the "green light" will go out, and the
display only shows the voltage value of the car battery.
d. Disconnect the jumpstarter clamps from the car
battery and exit the voltmeter function mode.

4.5 How to use the air compressor function

a. Please connect the air pipe to the output port of the air
pump, tighten the nut, and connect the other end to the
car tire;
b. Wake up the product first by
short press the LED light button or
the power, then hold the pump
button for 2 seconds to turn on the
function.
c. BAR、PSI；Short press BAR/PSI button to switch the tire pressure unit
Tire pressure
unit converting
chart
d. Set the target tire pressure value, be sure to confirm the tire pressure
requirements first;
Unit Bar
Value 1
KPa PSI
100 14.5
LOKITHOR
Kgf/cm2
1.02
09