Safety Instructions - Lokithor Aw401 Bedienungsanleitung

Error
NO.
code
13 430
14 440
15 450
16 470
17 480

9. Safety Instructions

Please read the User Manual carefully before using the LOKITHOR AW401
multi-function startup power supply
Please operate in strict accordance with the instructions, improper operation
1
may lead to serious safety accidents.
The starting power supply is only used to start the 12V engine, and cannot
2
start vehicles that exceed the specified displacement or exceed the specified
voltage (12V).
Forced start mode, in this mode, part of the safety protection mechanism is
3
invalid. Please use with caution, be sure to prevent short circuit to connect
wrong with positive and negative poles, otherwise it may cause accident.
Please check the operating instructions carefully before operation.
In air pump working mode, if not set the target tire pressure,but directly turn
4
on the air pump, the air pump will not automatically stop inflating which
needs to be turned off manually. If the tire pressure is not monitored in real
time, the tire pressure may be too high to burst.
During the normal operation of the air pump, high temperature will be
5
generated, especially of the air nozzle. Do not touch it immediately. It is
recommended to wear gloves to prevent high temperature burns.
When using the water pump, it is necessary to check if there is a power
6
supply around. Please avoid the power supply to avoid electric shock and
short-circuit fire.
The water pump must not suck in fluxes, liquids containing solvents or
7
undiluted acids. Also do not inhale gasoline, paint thinners and fuel oils, as
well as extremely flammable, explosive and toxic sprays.
Code Explanation
The external battery
voltage is greater
than the device
voltage
Clamps reversed
connected
Short circuit when
started
Voltage difference
protection before
starting
Continuous start
protection
Cause/Solution
1.If the displayed voltage is lower
than 12V, the device voltage is low,
please connect the charger to
supply power.
2.If the displayed voltage is higher
than 12V, the car battery is normal;
or the car battery voltage is too
high, which is not suitable for this
product. Please use an igniter that
supports higher voltage.
Connect the car battery correctly
Restart the device
Return to factory for repair
Wait 30 seconds to start again
LOKITHOR
13