TypeS StartYa 8Qi Gen2 Bedienungsanleitung Seite 29

Troubleshooting
Issue
Cannot jump start
LED light on the clamp
box keeps ashing
The wireless charging
feature does not charge
my smartphone.
Flashlight does not
turn on
No wall adaptor
WARNING: This Jump Starter is only intended to jump start 12V cars, trucks, boats, or motorcycles with an internal
combustion engine and single lead-acid battery systems. Do not use this device to jump start batteries outside of these four
types of vehicles; doing so may cause a re or other serious injuries. Refer to the user manual for additional safety information.
29
Cause Remedy
Wrong clamp Make sure to clamp the RED jumper cable to the POSITIVE
connection (+) post on the car battery. And BLACK jumper cable to
NEGATIVE (-) post or car interior. Refer to Page 6 for
details.
45-Second timer to Jump starter timed out. Disconnect the cables from the
jump start has expired. vehicle battery and reconnect.
Low battery status Recharge the unit via USB cable until at least 50% charge.
Protection circuit is Refer to the status table on the indicator box or page 8 of
working the manual.
Your smartphone Adjust your device on the wireless charging pad until it
cannot detect the starts charging.
wireless charging pad
signal. If your smartphone has a case thicker than 0.3 mm, you
may need to remove the case in order to charge your
smartphone wirelessly.
Your device does not The device you are charging must have the wireless
offer wireless charging charging feature in order to use the wireless charging pad.
feature.
Low battery Recharge the unit via USB cable.
The unit is charging As a safety precaution, the ashlight light will not work while
the unit is charging. Please unplug the unit from charging or
wait until the unit nishes charging before using the light.
Charge via USB cable Plug the USB cable into computer or any USB 5V 2A wall
adaptor.
EN