Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disconnect the cables from your vehicle within 30 seconds. First remove the BLACK/NEGATIVE (-)
8.
clamp and then the RED/POSITIVE (+) clamp.
9.
Do not allow the metal ends of the jumper cable clamps to touch each other, or the
touch anything metal on the car. Now unplug the
Starter. This will reset the jumper cables. In 30-seconds the jump starter will power o automatically.
10. Keep the engine running for 20 to 30 minutes, or drive the car to recharge the battery.
NOTE: If the engine dies shortly after it has been jump started, or as soon as the jumper cables are
disconnected, it probably means the vehicle charging system is not working (bad alternator, voltage
regulator, wiring problem, or loose/ dirty battery cables). Please seek professional help from an
auto mechanic to nd the root cause of the problem. The Jump Starter may not work correctly for
vehicles that require remote battery jumper locations (e.g.: battery located in trunk or other location).
Please consult the owner's manual for your vehicle.
24
GRAY
end of the jumper cables from the Jump
EN
RED
clamp to
Werbung
Inhaltsverzeichnis
