TypeS StartYa 8Qi Gen2 Bedienungsanleitung Seite 23

5. Check the LED status on the Polarity Circuit Protection Box. Proceed to the next step unless the
RED
LED is ashing
section.
6. Once the clamps are properly connected to the vehicle battery, the LCD Display will read: Ready,
Start vehicle ignition. You have 45 seconds to start your
vehicle before the Jump Starter shuts o in order to
prevent the vehicle battery from reverse charging the unit.
NOTE: If vehicle does not crank, or cranks very slowly, wiggle the cable clamps on the vehicle
battery to ensure they are making good contact. Wait 60 seconds before trying to jump start your
vehicle again. Each new jump start attempt requires disconnection of both clamps from the
vehicle battery and reconnection.
The engine should start if there are no other problems (such as a bad starter or ignition circuit
problem). Do not attempt to jump start the vehicle more than 3 times with the Jump Starter. If the
vehicle fails to start after 3 attempts, it is likely due to alternative reasons that should be checked by
an auto mechanic.
7. When the engine starts, the LED on the Polarity Circuit
Protection Box will blink
will also read: Successful jump, unplug cables.
23
and BEEPING. Reference Polarity Protection Circuit Status chart in the next
RED
and beep. The LCD Display
EN