Bestway LAY-Z-SPA S300202 Gebrauchsanweisung Seite 9

WARNINGS - SAFE SETUP AND STORAGE
• We strongly recommend not to unfolding and inflating the
spa if the ambient temperature is below 15°C (59°F). We
suggest inflating the spa indoors, and then continuing to
setup outdoors. If the outdoor temperature is lower than
6°C (42.8°F), the spa heater must always be on. In this
mode, the Freeze Shield™ system can keep the internal
temperature between 6°C (42.8°F) and10°C (50°F) to
prevent damage, such as water freezing in the pipes or the
circulation system.
CAUTION: If alarms pop up on the spa, the Freeze Shield™
system will stop working. Be sure to check the status of your
spa if the outdoor temperature is below 6°C (42.8°F). In case
of a long-term absence from home when there is a risk
of temperatures falling below 6°C (42.8°F), we strongly
suggest disassembling the spa and storing it following the
storage procedure.
• Do not leave the spa empty for extended period of time. Do
not expose the spa to direct sunlight for extended period of
time.
• When the appliance will be not used for a long time, such
as in the winter, the spa or pool set should be disassembled
and stored indoors.
• Do not to place the spa on a slippery surface and make
sure the surface is free of sharp objects before installation.
• To avoid damage to the pump, the spa must never be
operated unless the spa is filled with water.
• For safety reasons, only use the accessories provided or
approved by the spa manufacturer.
• Regarding the information pertaining to the installation, refer
to the following paragraph of the manual.
• Whenever the spa is emptied, the filter should be cleaned
(and drained/dried, where applicable).
• Please examine equipment before use. Notify Bestway at
the customer service address listed on this manual for any
damaged or missing parts at the time of purchase. Verify
9