Troubleshooting - Jägermeister 1BTMII-EU Bedienungsanleitung

Troubleshooting

Troubleshooting
Problem
Jägermeister is
dripping from the
bottlewell.
The device
consumes a lot of
energy and the
cooling capacity is
not optimal.
The bottle is dripping.
The device is not
cooling and the LEDs
are not lit.
44
Possible cause
The sealing rings
are not properly
positioned.
The bottle stoppers
are defective.
The sealing rings
are defective.
The air circulation
at the back and
bottom of the
device affects the
energy and the
cooling
performance.
The bottle stoppers
are not screwed on
properly.
The fuse may have
blown.
Action
Check the fit of the sealing
rings, if necessary, put
them in place.
Replace the bottle
stoppers.
Replace the sealing rings.
Make sure there is enough
free space at the back and
bottom of the device.
Make sure that the bottle
stopper is correctly seated
and screw it on properly if
necessary.
Replace the fuse (see
p. 46).