HBM Machines H130052 Bedienungsanleitung Seite 32

7. USING THE MANUAL FUNCTION
a) Pump the Evacuator Handle several times to create a vacuum. The brake fluid will flow through
the Suction Hose Assembly into the Reservoir until it has all been extracted OR until maximum
reservoir capacity has been reached.
8. Disconnect the Main Suction Hose from the Suction Hose Adapter.
9. Disconnect the Main Suction Hose from the Reservoir Cap. Pour the used brake fluid from the
Reservoir into a suitable container. Dispose of used coolant in accordance with federal, state and
local regulations.
EXTRACTING POWER STEERING FLUID FROM
THE POWER STEERING FLUID RESERVOIR
1. See "Preparing for Operation" instructions above.
2. Clean the exterior of the power steering fluid reservoir and reservoir cap to prevent dirt and debris
from entering the master cylinder when the cap is removed.
3. Insert the appropriate diameter Suction Hose Adapter into the master cylinder reservoir.
NOTE: DO NOT bend the Suction Hose Adapter while inserting the Hose Adapter into the reservoir.
4. Connect the Main Suction Hose to the inserted Suction Hose Adapter.
NOTE: Ensure that the hose connections are tight to prevent leakage during the extraction process.
5. Press the Main Suction Hose into the Reservoir Cap as described in the assembly instructions.
NOTE: Ensure that the Vacuum Release Plug is fully inserted in the lower receiving hole prior to
operation. If the Vacuum Release Plug is not inserted, a vacuum will not be created.
6. USING THE PNEUMATIC FUNCTION
a) Open the Air Valve on the Venturi to create a vacuum. The power steering fluid will flow through
the Suction Hose Assembly into the Reservoir until it has all been extracted OR until maximum
reservoir capacity has been reached.
b) Close the Air Valve on the Venturi and disconnect from the air source.
7. USING THE MANUAL FUNCTION
a) Pump the Evacuator Handle several times to create a vacuum. The power steering fluid will flow
through the Suction Hose Assembly into the Reservoir until it has all been extracted OR until
maximum reservoir capacity has been reached.
8. Disconnect the Main Suction Hose from the Suction Hose Adapter.
9. Disconnect the Main Suction Hose from the Reservoir Cap. Pour the used
power steering fluid from the Reservoir into a suitable container. Dispose of used coolant in
accordance with federal, state and local regulations.
MAINTENANCE
1.Always store the Pneumatic/Manual Fluid Extractor in a well-protected area where it will not be
exposed to inclement weather, corrosive vapors.abrasive dust, or any other harmful elements.
2.Keep the Pneumatic/Manual Fluid Extractor clean for better and safer performance.
3.Inspect the tank, Hoses, Caps, Gaskets, Seals, and Adapters periodically and, if damaged,
replace them.
4.Rinse the Extractor tank, pump, adapter, and tubes with clean solvent or engine degreaser, and
allow them to dry thoroughly.
7