Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SPECIFICATIONS
Working pressure: 85-120PSI
Capacity: 6L
Air inlet: 1/4"
Operation: Manual/Pneumatic
Application: Lubricating Oils, ATF, Coolant, Water, Other Low Viscosity Fluids
SAFETY WARNINGS
IMPORTANT INSTRUCTIONSAND SAFETY RULES
1.Know your tool. Read this manual carefully. Learn the tooPs applications and limitations, as well as
potential hazards specific to it.
2.Keep work area clean and well lit. Cluttered or dark work areas invite accidents.
3.Keep children away.AII children should be kept away from the work area. Never let a child handle a
tool without strict adult supervision.
4.DO NOT operate this tool if under the influence of alcohol or drugs.Read warning labels on prescrip-
tions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt,
DO NOT attempt to operate.
5.Use safety equipment. Eye protection should be worn at all times when operating this tool. Use
ANSI approved safety glasses. Everyday eye glasses are NOT safety glasses. Dust mask, non-skid
safety shoes, hard hat or hearing protection should be used in appropriate conditions.
6.Wear proper apparel.Loose clothing, gloves, neck-ties, rings, bracelets or other jewelry may present
a potential hazard when operating this tool. Keep all apparel clear of the tool.
7.DO NOT overreach. Keep proper footing and balance at all times when operating this tool.
8.Check for damage.Check your tool regularly. If part of the tool is damaged,
it should be carefully inspected to make sure it can perform its intended function correctly. If in doubt,
the part should be repaired.Refer all servicing to a qualified technician.Consult your dealer for advice.
9.Keep away from flammables. DO NOT attempt to operate this tool near flammable materials or
combustibles.Failure to comply may cause serious injury or death.
10.Store idle tools out of the reach of children and untrained persons.Tools may be dangerous in the
hands of untrained users.
11.Maintain tools with care.
12.Keep tools dry and clean.
13.Properly maintained tools are less likely to bind and are easier to control.DO NOT use a damaged
tool.Tag damaged tools "DO NOT USE" until repaired.
1
Werbung
Inhaltsverzeichnis
