HBM Machines H130052 Bedienungsanleitung Seite 27

14.Check for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tooPs operation.
15.If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained
tools.
16.Use only accessories that are recommended by the manufacturer for your model.Accessories that
may be suitable for one tool may become hazardous when used on another tool.
17.Tool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result in a risk of injury.
18.When servicing a tool, use only identical replacement parts. Use of unauthorized parts or failure to
follow maintenance instructions may create a risk of injury.
19.Maintain a safe working environment.Keep the work area well lit. Make sure there is adequate
surrounding workspace. Keep the work area free of obstructions, grease, oil, trash, and other debris.
DO NOT use this product in a damp or wet location.
SAFETY RULES & INSTRUCTIONS
1.Maintain labels and nameplates on this product. These carry important information.
2.Keep the handle dry, clean, and free from brake fluid, oil, and grease.
3.Before use, read and understand all warnings, safety precautions, and instructions as outlined in the
vehicle manufacturers service manual. It is beyond the scope of this manual to properly describe the
correct procedure and test data for each vehicle.
4.Always perform vehicle service in a properly ventilated area.Never run an engine without proper
ventilation for its exhaust. Stop work and take necessary steps to improve ventilation in the work area
if you develop momentary eye, nose, or throat irritation as this indicates inadequate ventilation.
5.Engine parts that are in motion and unexpected movement of a vehicle can injure or kill. When
working near moving engine parts, wear snug fit clothing and keep hands and fingers away from
moving parts. Keep hoses and tools clear of moving parts.Always stay clear of moving engine
parts.Hoses and tools can be thrown through the air if not kept clear of moving engine parts. The
unexpected movement of a vehicle can injure or kill. When working on vehicles, always set the
parking brake or block the wheels.
6.Be alert for hot engine parts to avoid accidental bums.
7.If the car was driven recently, fluids could be very hot.Allow at least 2 hours before you handle any
fluids. Oil and coolant burns are very dangerous.
8.Avoid accidental fire and/or explosion. DO NOT smoke near engine fuel and battery components.
9.Never remove the cap from the radiator or expansion tank while the engine is at operating tempera-
ture.
2