Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING! To extract certain fluids, the vehicle may need to be lifted.Practice
!
extreme caution when using lifting equipment, and ensure that the proper lifting
equipment is utilized. Prior to inserting the extraction hoses into any dipstick
tube/fluid reservoir, ensure that the extraction hoses are clean of any residual
fluids.This could cause contamination, potentially leading to system failure. This
system creates a vacuum, thus creating pressurized fluid. While operating,
ensure secure fittings and always check the system pressure prior to discon-
necting any hose.
TECHNICAL DESCRIPTION
ASSEMBLE
The Main Extraction Reservoir is fully assembled.
1.Remove the unit and all pieces from the packaging.
2.Refer to the parts list to ensure all pieces are present.
3.Press the Main Suction Hose into the receiving hole on the Reservoir Cap. Press in until snug
against the cap.The O-Ring will hold the Main Suction Hose in place during operation.
4.Remove the protective cover from the Venturi and install the Air Fitting.
5.Ensure that the Reservoir Lid is properly secured to the Reservoir.
6.If using shop air.connect the compressed air source to the Air Fitting installed on the Venturi.
OPERATION
PREPARING FOR OPERATION
1.Park the vehicle on a level surface, free from obstruction.Put the vehicle in park or neutral; apply the
parking brake.
Figure
Description
1
Extractor Tank
2
Sealing Cap
3
Main Suction Hose Receiving Hole
4
10mm MainSuction Hose
5
5mm Suction Probe
6
6mm Suction Probe
7
8mm Suction Probe
8
Venturi
9
Air Fitting
10
Base
4
Werbung
Inhaltsverzeichnis
