HBM Machines H130052 Bedienungsanleitung Seite 30

2.If extracting oil, start the engine and allow the engine to idle until it has reached normal operating
temperature.Turn the engine off.
NOTE: If extracting coolant, DO NOT follow Step 2. Allow the engine to cool completely before
proceeding.
EXTRACTOR OIL
1.Insert the Suction Probe(# 5/ #6 / #7) into the dipstick hole
until it reaches the bottom of the oil pan.
2.Connect the Main Suction hose (#4) to the adapter.
NOTE: Do not bend the hose.
Ensure that the hose connection are tight to prevent the
leakage during the extracting process.
3.Press the Main Suction Hose into the Sealing cap.
NOTE: Ensure that the Vacuum Release Plug is fully inserted in the lower receiving hole prior
to operation. If the Vacuum Release Plug is not inserted,vacuum will not be created.
4.USING THE PNEUMATIC FUNCTION
a) Open the Air Valve on the Venturi to create a vacuum.The oil will flow through the Suction Hose
Assembly into the Reservoir until it has all been extracted OR until maximum reservoir capacity has
been reached.
b) Close the Air Valve on the Venturi and disconnect from the air source.
5.USING THE MANUAL FUNCTION
a)Pump the Extractor Handle several times to create a vacuum.The oil will flow through the Suction
Hose Assembly into the Reservoir until it has all been extracted OR until maximum reservoir capacity
has been reached.
6.Disconnect the Main Suction Hose from the Suction Probe Adapter.
7.Disconnect the Main Suction Hose from the Cap.Pour the used oil from the extractor tank into a
suitable container. Dispose of used oil in accordance with federal, state and local regulations.
EXTRACTING COOLANT FROM A RADIATOR
OR EXPANSION TANK
WARNING:
DO NOT remove the cap from the radiator or expansion tank
!
while the engine is at operating temperature.This system is
under pressure and could cause serious injury. ALWAYS allow
the engine to cool completely prior to removing the radiator cap
or expansion tank cap.
5