AEG EEB331010M Benutzerinformation Seite 85

8.1 What to do if...
Problem
You cannot activate or oper‐
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
Hob²Hood does not work.
Automatic Heat Up does not
operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
comes on.
comes on.
Possible cause
The fuse is blown.
You touched 2 or more sen‐
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
You put something on one or
more sensor fields.
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
You covered the control pan‐
el.
The zone is hot.
The highest heat setting is
set.
Power management oper‐
ates.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated. Activate the sounds. Refer to
Automatic Switch Off oper‐
ates.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Remove the object from the
sensor fields.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Let the zone become suffi‐
ciently cool.
The highest heat setting has
the same power as the func‐
tion.
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
"Daily use".
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use".
Put cookware on the zone.
17