Switching On And Off; Changing The Rotational Direction (Reverse); Emptying The Collection Box; Overload Protection - Parkside PWH 2800 A1 Originalbetriebsanleitung

GB
the safety switch (10) are in the correct
position.
The device will not turn on if the
collection box and safety switch are
not in the correct position.

Switching on and off

Make sure that the mains voltage
matches the details on the type pla-
te.
1. Make a loop in the end of
the extension cable and
suspend this in the cable
strain relief (7) on the mains
cable (6).
2. Re-connect the extension cable.
3. Make sure that the hopper (3) is empty
before switching on.
4.
2
1
Turn the rotary switch to the right. The
device is now in continuous operation.
5. Fill the hopper with the material to be
shredded (3).
→
The material is drawn in and sh-
redded.
6. To turn off, turn the rotary switch (2) left
to the OFF position.
The device will continue to run after
switching off.
Changing the rotational
direction (reverse)
You can change the rotational direction of
the cutting roll (reverse) to remove jammed
material.
28
To start the device,
slide the rotary
switch (2) lock
(2a) in the direction
.
1.
1
2. Turn the rotary switch to the left. The
device is now in inching mode.
→
jammed shredded material is re-
leased.
3. Change the rotational direction again
to continue shredding (see section
"Operation/switching on and off").
Emptying the collection
box
Empty the collection box regularly.
Be aware that the collection box fills
unevenly under the discharge chute!
1. Switch off the device and unplug the
mains plug from the socket.
2. Unlock the collection box (11) by mo-
ving the safety switch (10) to the "OFF"
position.
3. Remove the collection box from the
chassis (9) and empty it.
4. Make sure that the area around the sa-
fety switch is free of wood chips before
inserting the collection box again.
5. Put the collection box back in place
and move the safety switch up as far as
it will go.

Overload protection

If the motor is overused, e.g. if the cutting
roll is blocked due to branches that are too
thick, the device switches off automatically.

Restart lock

If the device automatically shuts down due
to overuse, it will not restart automatically.
Slide the rotary
switch ( 2) lock
2
( 2a) in the direc-
tion of the power
cable.