Residual Risks; Assembly Instructions; Unpacking; Assembling The Device - Parkside PWH 2800 A1 Originalbetriebsanleitung

• Only use splash-proof extension
cables approved for outdoor
use. The strand cross-section of
the extension cable must be at
least 2.5 mm
25 m and 2.5 mm
over 25 m. Always roll out the
cable drum completely before
use. Check the cable for dama-
ge.
• Do not use the cable to pull the
plug from the socket. Protect the
cable from heat, oil and sharp
edges.

Residual risks

There will always be residual risks
even if you operate this electrical
tool according to the instructions.
The following hazards may occur
in connection with the type and de-
sign of this power tool:
a) hearing damage if suitable ear
protection is not worn.
b) eye damage if no suitable eye
protection is worn.
Warning! During operation,
this power tool produces an
electromagnetic field. Under
certain circumstances, this
field may negatively affect
active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, users who wear me-
dical implants must consult
their doctor and the manu-
facturer of the implant before
operating the machine.
for cables up to
2
2 for cables

Assembly instructions

Unpacking

1. Remove the device from the packaging.
2. Make sure that the safety switch (10) is
set to the "OFF" position and remove
the collection box (11) from the chassis
(9).
3. Remove the shredding attachment and
accessories.
4. Check the scope of delivery:

Assembling the device

1. Screw the two wheels (13) to
the chassis (9) with the mounting
material provided.
2. Clip the wheel covers (14) into
the wheels (13).
3. Screw the two adjustable feet
(12) to the chassis (9).
4. Place the shredder onto the hop-
per (3). Fasten the shredding at-
tachment (5) to the chassis (9) with
the four screws (21) provided.
5. Make sure that the safety switch
(10) is set to the "OFF" position.
6. Slide the collection box (11)
along the guide rail into the
chassis (9). The collection box
can only be inserted in one di-
rection.
7. To lock the collection box, push
the safety switch (10) up as far
as it will go.

Operation

Initial start-up

Before initial start-up, check that the shred-
ding attachment is attached to the chassis
correctly and that the collection box and
GB
27